Bringing machine 'default' up with 'virtualbox' provider...
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] Writing the following entries to (/etc/hosts)
==> default: [vagrant-hostsupdater] 192.168.33.10 localhost # VAGRANT: 47b6411ff94530fc86a77969c30feebb (default) / e821a431-78fa-43f6-b4ca-08fc7450baa1
==> default: [vagrant-hostsupdater] This operation requires administrative access. You may skip it by manually adding equivalent entries to the hosts file.
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: Clearing any previously set forwarded ports...
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
default: Adapter 1: nat
default: Adapter 2: hostonly
default: Adapter 3: bridged
==> default: Forwarding ports...
default: 22 (guest) => 2222 (host) (adapter 1)
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
default: SSH address: 127.0.0.1:2222
default: SSH username: vagrant
default: SSH auth method: private key
==> default: Machine booted and ready!
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
[default] GuestAdditions 6.1.18 running --- OK.
==> default: Checking for guest additions in VM...
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: [vagrant-hostsupdater] Checking for host entries
==> default: [vagrant-hostsupdater] found entry for: 192.168.33.10 localhost
==> default: Setting hostname...
==> default: Configuring and enabling network interfaces...
The following SSH command responded with a non-zero exit status.
Vagrant assumes that this means the command failed!
/sbin/ifdown 'eth1' || true
/sbin/ip addr flush dev 'eth1'
/sbin/ifdown 'eth2' || true
/sbin/ip addr flush dev 'eth2'
# Remove any previous network modifications from the interfaces file
sed -e '/^#VAGRANT-BEGIN/,$ d' /etc/network/interfaces > /tmp/vagrant-network-interfaces.pre
sed -ne '/^#VAGRANT-END/,$ p' /etc/network/interfaces | tac | sed -e '/^#VAGRANT-END/,$ d' | tac > /tmp/vagrant-network-interfaces.post
cat \
/tmp/vagrant-network-interfaces.pre \
/tmp/vagrant-network-entry \
/tmp/vagrant-network-interfaces.post \
> /etc/network/interfaces
rm -f /tmp/vagrant-network-interfaces.pre
rm -f /tmp/vagrant-network-entry
rm -f /tmp/vagrant-network-interfaces.post
/sbin/ifup 'eth1'
/sbin/ifup 'eth2'
Stdout from the command:
Failed to bring up eth1.
Failed to bring up eth2.
Stderr from the command:
/sbin/ifdown: interface eth1 not configured
/sbin/ifdown: interface eth2 not configured
/etc/network/if-up.d/sendmail: 44: .: Can't open /usr/share/sendmail/dynamic
run-parts: /etc/network/if-up.d/sendmail exited with return code 2
Internet Systems Consortium DHCP Client 4.3.3
Copyright 2004-2015 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/eth2/08:00:27:b1:d2:e8
Sending on LPF/eth2/08:00:27:b1:d2:e8
Sending on Socket/fallback
DHCPDISCOVER on eth2 to 255.255.255.255 port 67 interval 3 (xid=0x51736274)
DHCPREQUEST of 192.168.1.84 on eth2 to 255.255.255.255 port 67 (xid=0x74627351)
DHCPOFFER of 192.168.1.84 from 192.168.1.1
DHCPACK of 192.168.1.84 from 192.168.1.1
/sbin/dhclient-script: 28: .: Can't open /usr/share/sendmail/dynamic
DHCPDECLINE on eth2 to 255.255.255.255 port 67 (xid=0x74627351)
Unable to obtain a lease on first try (declined). Exiting.
